Epilog FiberMark 24 Firmware and Driver Downloads

Driver Update Notification Signup

Signup to receive email notification when a new driver or firmware is available for your laser model.

Signup Now

FiberMark Driver 9.02 (01/07/2015)

Replaces 9.01 (08/15/2014)

Windows 10: You do not need to upgrade your driver when upgrading to Windows 10.
Warning: If you have previous DAT files, you will need to use the DAT converter, found below.
Fix for vector sorting commands sent to Job Manager.
Works with newest version of the Epilog Job Manager.
Optional: Download individual files.
Download install instructions.

Download Now

DAT Converter (08/15/14)

Convert your DAT files if using PC driver version 8.06 or earlier.
Download install and use instructions.

Download Now

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)

Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

64 bit

Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
For more information on the Job Manager, click here.
Download install and use instructions.

Download Now

32 bit

Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
For more information on the Job Manager, click here.
Download install and use instructions.

Download Now

Firmware: 1.0.1.6 (02/04/11)

Replaces 1.0.1.5