Skip to main content
Home  /  Technical Support  /  Driver Updates  /  FiberMark S2 Drivers

FiberMark S2

Firmware & Driver Downloads

Signup to receive email notification when a new driver or firmware is available for your laser model.
FiberMark S2 landscape

Software/Firmware for FiberMark S2 Laser Systems

Software Suite 2.2.5 (2/1/2021)

  • Everything you need to run your FiberMark S2 system
  • Installs the Epilog Job Manager and the Epilog Laser Dashboard
  • For more information on the Job Manager, click here.

Version 2.2.5 Release Notes:

  • Bug fixes and improvements

Minimum Requirements:

  • Please note: Windows 7/8.1/10 is required to use the Epilog Job Manager.
  • Operating system should have all system updates before installation
  • Support for OpenGL 3.0 (or higher) or OpenGL 2.0ES (or higher)
  • 4GB RAM or more
  • 2 processor cores or more
  • Processor can be any Intel i3/i5/i7, AMD Ryzen 3/5/7, AMD A4/A6/A8/A10/A12/FX
  • Integrated gigabit ethernet required for Fusion M2 vision system. Fusion Pro/Edge does not have the same requirement, but is nice to have.

Recommended Specifications:

  • 8GB RAM or more
  • 4 processor cores or more
  • Processor can be any Intel i5/i7, AMD Ryzen 5/7, AMD A6/A8/A10/A12/FX

Please note: Remove previous version of Epilog Job Manager and Epilog Software Suite before installation! (Go to Control Panel > Programs and Features and remove the software.)

Firmware: 1.0.1.6 (02/04/11)

Replaces 1.0.1.5
  • This release addresses CE requirements to stop the motion control system if the access door is opened while the machine is operating.

Firmware & Driver Downloads



Technical Specifications

Technical specifications for FiberMark S2 system.